![]() If you have followed all the steps but can't wake up your PC anyway, try doing an online search on how to modify your computer's BIOS settings in order to allow Wake on LAN. Since the process of reaching the BIOS menu and change its settings is dependent on a PC's motherboard manufacturer, this part is not included in the step-by-step instructions. In order for Wake on LAN to work, some PCs will require you to set up some additional power management settings in the PCs BIOS menu. Put your PC to sleep and click the "Wake device" button to test if your configuration works. Find the relevant network adapter and copy its MAC (Physical) Address into the router's WOL configuration ( Services → Wake on LAN): ![]() This action will display all network interface related information. Now open the Windows Command Prompt (press Windows Key + R and search for "cmd") and enter the ipconfig /all command. Then enter the Power Management tab and place a check mark next to the Allow this device to wake the computer option:. ![]() Go to the Advanced tab, find and select the Wake on Magic Packet option and set its value to Enabled:.Right click on the adapter and select Properties: Open the Windows Device Manger (press Windows Key + R and search for "device manager") and find your Ethernet network interface card under the Network adapters section.A PC with a Wake on LAN compatible network card.For example, if the client address is 192.168.1.12, the broadcast address used in the packet would be 192.168.1.255.This article contains a step-by-step guide on how to make a Windows PC Wake on LAN compatible so that it can be woken up by a RUT router's WOL feature. ![]() It may be necessary to change the address to broadcast the packet to the whole network. If an IP address is specified in the magic packet, then the network switch may not properly broadcast it to the whole network.Confirm that the MAC address used in the magic packet matches the MAC for Ethernet 1 on the client computer.Confirm that the computer sending the magic packet can ping the client computer.These settings can override the BIOS in Windows 8 or Windows 10. Check the network adapter driver properties in Windows and ensure that WOL is enabled there.There is some interaction between the BIOS settings and the network adapter driver settings in Windows 8. It may be necessary to boot to the Windows desktop after changing the BIOS settings in order for them to be properly applied.This power-saving setting turns off the network adapter. Ensure that Deep Sleep is disabled in the BIOS (not applicable to all computers).Ensure that WOL is enabled in the BIOS under Power Management settings.If there is no link light, then there is no way for the network adapter to receive the magic packet to wake the computer. Confirm that the link light remains on when the computer is powered off.WOL does not work when the computer is running on battery. Confirm that the AC power is plugged in.Once you have confirmed that the network cable is connected to the network adapter on the computer, if WOL still does not function properly, troubleshoot using the following steps: Ensure that any USB network adapter is WOL capable, before any troubleshooting of the computer. Computers without an integrated network jack need a USB Dongle that is WOL-compliant. This article assumes that Power On By PCI-E or WOL (Wake-on-LAN) is enabled in your BIOS. Here's how to enable or disable Wake On Lan (WOL). NOTE: Most modern computers are equipped with an RJ45 network jack. Wake On Lan is a Windows feature that allows your network card to wake your computer from sleep or shut down over the network or remotely.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |